Sylvania SRZ3000 User Manual

Page 24

1A23

Connections

1 Use a standard antenna cable to connect the wall jack to the ANT. IN jack on STB.

2 Use a standard audio cable to connect the audio output jacks (L, R) on STB to the audio input jacks (L, R)

on the stereo.

3 Connect STB and the TV with a video cable.

NOTE:

Refer to the pages describing the connection to TV.

4 Set the video resolution selection switch to “1080i.”

NOTE:

For the capability of your TV and further information, refer to TV owner’s manual.

5 Plug the AC power cord of the stereo into the AC outlet, then turn the stereo on.

6 Set the stereo to the input mode to which you connected the audio from the STB.

NOTE:

Refer to the stereo owner's manual for further information.

7 Plug the AC power cord of STB into the AC outlet, then turn STB on.

STB connection to a standard stereo system

STEREO COMPONENT

Rear panel of STB

Audio cable

To audio input jacks
(L, R)

To component video input
jacks (Y/ Pb/ Pr)

Component video cable

NOTE:
Component video cable and audio cable are not included.

ST200.qxd 03.3.19 7:05 PM Page 24