Sylvania SRZ3000 User Manual

Page 21

1A23

Connections

1 Use a standard antenna cable to connect the wall jack to the ANT IN jack on STB.

2 Use a standard audio cable to connect the audio output jacks (L, R) of STB to the audio input jacks (L, R) on

the TV.

NOTE:

If your TV is monaural (MONO) and has only one audio jack, use a standard audio cable (white) to
connect the audio output jack (white) on STB to the audio input jack (white) on the TV. The red cable and
jack will not be used.

3 Use a component video cable to connect the component video output jacks (Y/ Pb/ Pr) on STB to the

component video input jacks (Y/ Pb/ Pr) on the TV.

4 Set the video resolution selection switch to “1080i.”

NOTE:

For the capability of your TV and further information, refer to TV owner’s manual.

5 After completing the connection to the TV, plug the AC power cord of the TV into the AC outlet, then turn

the TV on.

6 Set the TV to the input mode.

NOTE:

Refer to the TV owner’s manual for further information.

7 Plug the AC power cord of STB into the AC outlet, then turn STB on.

2 Connections

ST200.qxd 03.3.19 7:05 PM Page 21