Recording a cassette or md – Roland CD-2e User Manual
Page 44
44
Recording a Cassette or MD
Here’s how to record the sound from a cassette or MD.
4
Connect your audio device (e.g., cassette deck) to the CD-2e’s LINE IN
jacks.
Use audio cables to connect the CD-2e’s LINE IN jacks to the output jacks of your audio
device (e.g., cassette deck).
fig.connect-record-e.eps
5
Turn the [LINE] knob to adjust the input level at the LINE IN jacks.
Adjust the loudness of the sound you’re recording. Since you’re not using the mic input,
set the [MIC LEVEL] switch to the “MANUAL” position, and then turn the [MIC] knob all
the way to the left (off).
While playing the song to be recorded, turn the [LINE] knob to adjust the input level.
Adjust the level so that the peak indicator located above the [LINE] knob lights briefly
during the loudest passages of the song that’s being recorded.
fig.rec-line-e.eps
If you’re recording to an SD
memory card
If you’re recording to a
CD-R/RW disc
1
Turn on the power.
(
☞
1
Turn on the power.
(
☞
2
Insert the SD memory card.
(
☞
2
Insert the CD.
(
☞
3
Set the audio source to “SD.”
Press the [SD CARD] button so it’s lit.
fig.selectCD-e.eps
3
Set the audio source to “CD.”
Press the [CD] button so it’s lit.
fig.selectSD-e.eps
To the output jacks of
the audio device (amp)
CD-2e: RCA phono type
Audio device: RCA phono type
* Portable players use a stereo mini type jack
Types of plugs that can be connected
R
L
Louder
Quieter
At this position
Peak indicator
The level meter will move according
to the level of the audio input.
CD-2e_e.book 44 ページ ２００７年１０月２４日 水曜日 午前１１時１６分