Ryobi RY09905 - Manual (Page 11)

11
Vacuum
inleT door
door Tab
INSTALLING THE VACUUM TUBES
See Figures 7 - 8.
WARNING:
Rotating impeller blades can cause severe injury. Always
stop the engine before opening the vacuum door or in-
stalling/changing tubes. Do not put hands or any other
object into the vacuum tubes while they are installed on
the unit.
NOTE: This vacuum/blower is equipped with a vacuum door
interlock. If vacuum door is open and vacuum tubes are not
installed, engine will not start.
To install the vacuum tubes:
 Secure the upper and lower vacuum tubes together by
aligning the raised locking tabs with the raised slots.
 Tap tube assembly on ground until the screw holes in
lower tube are in the raised slot of the upper tube. Secure
with supplied screws.
 Depress door tab and open vacuum inlet door.
 Align tabs on housing with tube assembly. Insert tube
assembly into vacuum opening. Twist clockwise and lock
the upper vacuum tube into the blower housing.
To remove the vacuum tubes:
 Twist to loosen the upper vacuum tube by turning coun-
terclockwise.
 Remove the vacuum tube assembly from the blower
housing.
 Close the vacuum inlet cover door securely.
Fig. 8
Fig. 7
Vacuum
openinG
Vacuum Tube
aSSemblY
upper
Vacuum Tube
lockinG Tab
ASSEMBLY
Vacuum
inleT door
lockinG Tab
Vacuum baG
aSSemblY
Vacuum
door hinGe