Radio Shack ET-905 - Manual (Page 17)

17
REPLACING THE
HANDSET BATTERY
When the handset’s battery no long-
er recharges, replace the battery.
Use only a 3.6V, 650 mA battery with
a connector that fits the connector in
the battery compartment. You can
order a replacement battery from
your local Radio Shack store.
1. Press down on top of the hand-
set’s battery compartment cover
(on the three raised bars on the
lower back) and slide it off.
2. Using a Phillips screwdriver, turn
the stainless steel strap’s screw
counterclockwise to loosen it
slightly.
3. Turn the steel strap clockwise
and pull back to release it.
4. Remove the battery pack and
pry out the battery wires’ plug
using a small flat-blade screw-
driver.
5. Insert the new battery pack’s
plug into the receptacle and
firmly push down to make sure it
is properly connected.
6. Insert the steel strap’s hooked
end into the slot beside the bat-
tery connector and hold it up
while you place the new battery
pack in the compartment.
43-1080.fm Page 17 Tuesday, August 17, 1999 1:51 PM