Roland FJ-40 - Manual (Page 22)

20
2 Basic Operation
Pass the end of the material through the unit from back
to front.
Line up the end of the material with the lines of
reflective tape.
If the front edge of the material has been cut at an
angle, pull out the material so that all of the material
covers the reflective tape. 5
With the material pulled out from the roll stretched
taut with no slack, move the sheet loading lever
toward LOAD.
The pinch rollers lower to hold the material in place. 6
Fit the right-hand media flange all the way into the hole on the right-hand side of the roll material, and tighten the retainer screw
to secure in place. 4
Place the roll material on the shaft and fit the hole at the left-hand side all the way onto the left-hand media flange. 3
Rear
Roll material
Front
Front edge of the material
Reflective tape
Sheet loading lever
Rear
Entire material
stretched taut
Close the front cover, and press the [SETUP] key.
This detects the width of the material and displays the
printable width. 7
W 1234 mm
FINE BI-DIR
Top menu
The SETUP LED lights up