Radio Shack Auvio 40-294 - Manual (Page 13)

13
A
d
d
it
io
n
a
l I
n
fo
Select Source
To play devices connected to your soundbar, you must select the correct input source.
1. Press FUNCTION repeatedly to select:
„ IN1 or IN2 to play devices connected to
Audio Inputs.
„ AUX to play device connected to the line
input jack.
Additional Information
Troubleshooting
Problem Possible Solution
No sound Make sure the power cord is plugged in.
The batteries in the remote control may be dead. Replace the
batteries and try again.
The power outlet may be faulty. Plug in another device. If it
does not work, have an electrician inspect the outlet.
Reset the soundbar. Turn off the soundbar and unplug the
power cord from the wall. Wait a few seconds, then plug the
power cord back into the AC outlet.
Check all wire connections. See pages 8-9.
Remote control does not
work.
Replace batteries in the remote control.
Be sure batteries are installed with correct polarity.
Remove any obstacles between the remote control and TV.
Poor FM reception Make sure FM antenna is plugged in.
Specifications
Output Power/Ch (@ 10% THD) ............................... 12.5W x 2 + 25 W (Total 50W RMS/ 100W Peak)
Freq. Response ............................................................................................................... 50Hz ~ 20KHz
Operation Power .......................................................................... 100V~240V AC 50/60Hz.DC:15V 4A
Weight .........................................................................................................................155.2 oz (4400g)
Dimensions (H × W × D) ....................................................4.9 Ч 31.2 Ч 5.3 in (12.5 Ч 79.4 Ч 13.4 cm)
Specifications are subject to change and improvement without notice. Actual product may vary from the
images found in this document.
IN1