Radio Shack 900 MHz Digital Spread Spectrum Dual Keypad Cordless Telephone with Caller ID/Call Waiting ID - Manual (Page 15)

15 Operation
plays. Then press TALK and the phone dials
the number.
To dial the last number dialed using the
base, press
SPEAKER then REDIAL .
Notes:
• The redial memory for each keypad is
separate. You cannot redial a number
you dialed on the handset’s keypad
using
REDIAL on the base’s keypad, and
vice versa.
• On the handset, you can also press
RDL/PAUSE after pressing TALK to dial
the last number dialed.
• The redial memory holds up to 32 digits,
so you can redial long-distance as well
as local numbers.
• The redial memory also holds pause
entries. See “Entering a Pause” on
Page 18.
USING FLASH
FLASH performs the electronic equivalent of
a switchhook operation for special services,
such as Call Waiting.
For example, if you have Call Waiting, press
FLASH to answer an incoming call without
disconnecting the current call. Press FLASH
again to return to the first call.
Note: If you do not have any special phone
services, pressing
FLASH might disconnect
the current call.
USING TONE SERVICES
ON A PULSE LINE
Some special services, such as bank-by-
phone, require tone signals. If you have
pulse service, you can still use these special
tone services by following these steps.
1. Be sure DIAL MODE is set to P .
2. Dial the service’s main number.
3. When the service answers, press * /
TONE/
6 6 6 6
on the handset ( TONE on the
base). Any additional numbers you dial
are sent as tone signals.
When you hang up, the phone automatically
resets to pulse dialing.
USING PAGE/INTERCOM
You can use the phone as a two-way pager
and intercom between the base and the
handset. This is useful if the handset is away
from the base and you want to locate it, or if
you want to converse with someone through
the intercom.
To page the base from the handset, press IN-
TCM . Paging Base appears, and the base
and handset ring. Press SPEAKER or INTCM/
PAGE on the base to answer the page. In-
tercom appears.
To page the handset from the base, press IN-
TCM/PAGE . The handset and base ring, and
Paging appears. Press TALK or INTCM on
the handset to answer the page. Intercom
appears.
To end an intercom call, press TALK on the
handset, press SPEAKER on the base, or
hang up the handset.
If a call comes in during an intercom conver-
sation, either the person at the base or the
person at the handset can answer the call.
Press TALK on the handset or SPEAKER on
the base once to end the intercom call, then
press
TALK or SPEAKER again to answer the
incoming call.
Note: You can use the intercom while a call
is on hold, but not during a conversation.
43-5520.fm Page 15 Friday, July 21, 2000 8:01 AM