Radio Shack 900 MHz Digital Spread Spectrum Dual Keypad Cordless Telephone with Caller ID/Call Waiting ID - Manual (Page 12)

12 Installation
not press the access code number
either.
If the dial tone stops, you have touch-
tone service. Leave
DIAL MODE set to T .
If the dial tone continues, you have
pulse service. Set
DIAL MODE to P
(pulse).
SETTING THE RINGER
TONE/VOLUME
You can select one of four different ringer
tone/volume settings on the handset. Re-
peatedly press
VOL/CID
8 8 8 8
or
9 9 9 9
(except
during a call) to select the desired ringer set-
ting. Each time you press a button, the
phone rings at the selected setting and the
display shows
Ringer A High , Ringer A
Low , Ringer B High , or Ringer B Low .
Note: Pressing VOL/CID
8 8 8 8
when the phone
is set to Ringer A High or VOL/CID
9 9 9 9
when the phone is set to Ringer B Low
does not change the setting. Press the oppo-
site arrow key to change the setting.
To set the base’s ringer volume, set RING
VOL on the back of the base to OFF , LO , or
HI .
Notes:
• When you set RING VOL to OFF , the
base (and the handset if it is on the
base) does not ring but another phone
connected to the same line rings. If the
handset is away from the base, the
handset also rings.
• When you set the auto talk function to
off, the handset rings when you lift the
handset from the base. See “Turning
Auto Talk On/Off.”
TURNING AUTO
TALK ON/OFF
Your phone is preset so you must press
TALK when you lift the handset from the base
to answer a call. With auto talk turned on,
you can answer a call by just lifting the hand-
set from the base. If the handset is away
from the base, you can answer by pressing
any key.
Follow these steps to turn auto talk on or off.
1. Lift the handset and hold down CALL ID .
A menu appears with Auto Talk
selected.
2. Press SELECT/CHANNEL to change the
auto talk setting. On or Off appears
indicating the selected setting.
3. Return the handset to the base or press
CALL ID to store the new setting.
TURNING CALLER ID/
CALL WAITING ON/OFF
If you subscribe to Call Waiting with Caller ID
service, you can set the phone to show Call-
er ID information for an incoming call even
while you are using the phone.
Follow these steps to turn the Caller ID/Call
Waiting feature on or off.
1. Lift the handset and hold down CALL ID .
2. Press 2 or VOL/CID
9 9 9 9
to select CIDCW
(Caller ID/Call Waiting).
3. Press SELECT/CHANNEL to change the
Caller ID/Call Waiting setting. On or
Off appears indicating the selected
setting.
Return the handset to the base to store the
new setting.
43-5520.fm Page 12 Friday, July 21, 2000 8:01 AM