RCA RC5920P - Manual (Page 22)

Connections & Setup
20 Chapter 1
Installing Batteries in the Remote
1. Remove the battery compartment cover on the back of the remote.
2. Insert new batteries. Match the polarities (+ and –) on the batteries with the
diagram on the remote.
3. Put the battery compartment cover back on the remote.
Important Battery Information
• If you’re not going to use the remote for a month or more, be sure to remove
the batteries because they can leak and cause damage.
• Dispose of batteries in the proper manner, according to federal, state, and
local regulations.
• Any battery may leak electrolyte if mixed with a different battery type, if
inserted incorrectly, if all batteries are not replaced at the same time, if
disposed of in fire, or if an attempt is made to charge a battery not intended
to be recharged.
• Discard leaky batteries immediately. Leaking batteries can cause skin burns or
other personal injury.
Point the Remote in the Right Direction
When you want the remote to operate the DVD Player, point the remote at the
DVD Player, not the TV. The remote has to be pointed in the correct direction
and toward the correct component in order for the remote’s signal to
communicate with the sensor on the component. Make sure there is a clear path
between the remote and the component you want to operate so the signal isn’t
blocked.
Turn on the TV and DVD Player
1. Turn on your TV and tune to the correct video input channel (see following
page).
2. Press the DVD button on the DVD remote or the POWER button on the
DVD player.