Radio Shack Digital Answering System with Big Button Trim Phone - Manual (Page 13)

13 Installation
Directly on the Wall
To mount the system on a wall, follow these steps.
Note: For direct wall mounting, drill two holes 3 1 /
4
inches (82.5 mm) apart, one below the other. Then
thread two screws (not supplied) into each hole, let-
ting the heads extend about
1 / 4 inch (6.3 mm) from
the wall. (Be sure to use screws with heads that fit
into the keyhole slots on the bottom of the system.)
1. Plug one end of the supplied long modular cord
into the modular jack on the bottom of the sys-
tem near its back end.
2. Route the phone cord into
the groove on the bottom
of the system by sliding
the cord under the tabs
along the groove.
3. Plug the other end of the
cord into a modular phone
jack.
4. Fit the heads of the
screws into the keyhole
slots on the bottom of the
system, then slide the sys-
tem down until it is secure.
1 /
4
3 1 /
4
Phone
Cord
Groove
Tabs
Modular
Jack
Keyhole
Slots Handset
Jack
Handset
Groove
43-3804.fm Page 13 Thursday, July 6, 2000 2:35 PM