Radio Shack Digital Answering System with Big Button Trim Phone - Manual (Page 12)

12 Installation
2. Attach the battery to the terminals, then place it inside the
compartment.
3. Replace the cover.
If the LOW BATT indicator blinks while the AC adapter is prop-
erly connected, replace the battery.
Warning: Dispose of the old battery promptly and properly. Do
not burn or bury it.
Cautions:
• To avoid losing stored information, be sure the AC adapter
is plugged in and connected to the system before you
replace the battery.
• If you do not plan to use the system for 30 days or longer,
remove the battery. Batteries can leak chemicals that can
destroy electronic parts.
MOUNTING THE SYSTEM
On a Desktop
1. Plug one end of the supplied long modular cord into the
modular jack on the bottom of the system near its back end.
2. Route the phone cord into the groove on the bottom of the
system so it feeds out the back of the system and the sys-
tem sits flat.
3. Plug the other end of the cord into a modular phone jack.
Then proceed to “Connecting the Handset” on Page 14.
43-3804.fm Page 12 Thursday, July 6, 2000 2:35 PM