Regency E21-NG2 - Manual (Page 20)

20 Regency ® E21-2 Gas Fireplace Insert
FULL SCREEN DOORS
1) Hold the full screen door up against the unit in order to make the
following wire connections.
Pull the ON/OFF connector wires thru the box and connect them to
the switch.
Connect the fan switch wires with the wire connectors from the fan
speed control. Place clips over wires and tuck into side trim.
2) Lift the unit up slightly and push down on the corners of the Bottom
Trim Bracket and slide under unit.
Bottom Trim
Bracket
Push in Corners
3) Completely secure full screen door to the unit by securing 4 screws
to the Left and Right Side Trim.
4) Secure the Top Frame by sliding it on the screws at the top of the full
screen door. It is held in place by magnets.
Top Frame
Screw
INSTALLATION