beautypg.com

Installation, Installation of the dc sparker – Regency E21-NG2 User Manual

Page 18

background image

18

Regency

®

E21-2 Gas Fireplace Insert

17) Verify that if the conversion is from NG to

LPG, the screw must be re-assembled
with the red o-ring visible (Fig. 5).

18) Re-assemble the black protection cap

(Fig. 6).

WARNING!

Also check that the pilot and main

burner injectors

are appropriate for the gas type.

LPG Configuration

Red o-ring visible

Fig.5

Fig. 6

Installation of the DC Sparker:

24) Locate the Piezo Ignitor situated at the

side of valve.

25) Remove the Piezo Ignitor by unscrewing

the nut at the back of the mounting
bracket.

26) Disconnect the ignitor wire from the

Piezo Ignitor and connect it to the DC
Sparker.

Piezo

Ignitor

Ignitor

Wire

Piezo

Ignitor

Ignitor

Wire

DC

Sparker

27) Install the 3/4" nylon plug to cover up the

hole on the mounting bracket.

28) Connect the DC spark generator wires

to the SIT Valve with the screw, which is
provided in the kit.

22) Attach the label "This unit has been

converted to LPG" near or on top of the
serial # decal.

23) Replace the yellow "NG" label with red

"LPG" label.

19) Replace Burner Tray and reverse steps

6) to 1).

20) Adjust the burner aeration setting from

1/8" to 3/16" as required for the best
fl ame picture.

21) Remove the switch cover from the

left side of the body base and pull the
thermodisc out of the bracket under
the left side of the fi rebox bottom and
replace with the Thermodisc supplied
with this kit.

Remove the 2 nuts holding the switch box in

place, then pull the

thermosdisc out of the bracket.

16) Using the Allen wrench as shown in

Fig.4, rotate the screw clockwise until
snug, do not overtighten.

Fig.4

WARNING!

Do not overtighten the screw.

Recommended to

grip the wrench by the short side.

14) Check that the screw is clean and if

necessary remove dirt.

15) Flip the screw (Fig. 3).

Fig.3

INSTALLATION