Roberts Radio CRD40 - Manual (Page 34)

33
Specifi cations
Power Requirements
Mains AC 230 volts, 50Hz only
Battery (Remote control) 2 x AAA
Frequency Coverage
FM 87.5-108MHz
DAB 174.928 - 239.200MHz
Circuit features
Loudspeaker 2 x 76 mm 8 ohms
Headphone socket 3.5mm dia
Auxiliary in socket 3.5mm dia
Aerial System FM Wire aerial
DAB Wire aerial
General
Do not allow this radio to be exposed to water, steam or sand. Do not
leave your radio where excessive heat could cause damage. It is recom-
mended that the DAB band be used wherever possible as better results
in terms of quality and freedom from interference will usually be obtained
than on the FM band.
• The name plate is located on the underside of your clock radio.
The Company reserves the right to amend the specifi cation without notice.
• The apparatus shall not be exposed to dripping or splashing and
that no objects fi lled with liquids, such as vases, shall be placed on
the apparatus.
• It is recommended to operate the product such that there is a minimum
distance (10cm recommended) to adjacent objects in order to ensure
good ventilation.
• The ventilation of the product should not be restricted by covering it or
its ventilation openings with items such as newspapers, table-cloths,
curtains etc.
• No naked fl ame sources such as lighted candles should be placed on
the product.
• It is recommended to avoid using or storing the product at extremes
of temperature. Avoid leaving the unit in cars, on window sills in direct
sunlight etc.