Roland KC-880 - Manual (Page 9)

9
Connect your KC-880
Refer to the following diagram and connect the KC-880 to the external equipment you are using.
fig.connect.eps
* To prevent malfunction and/or damage to speakers or other
devices, always turn down the volume, and turn off the power on all
devices before making any connections.
Set all of the KC-880’s channel volume knobs (CH 1, CH 2, CH 3 and
CH 4) and AUX IN/MONITOR IN [LEVEL] knob as well as the
[VOLUME] knob to zero.
* The pin assignment for the XLR type connectors is as shown below.
Before making any connections, make sure that this pin assignment
is compatible with that of all your other devices.
fig.XLR.eps
* When connection cables with resistors are used, the volume level of
equipment connected to the inputs (CH 1 through CH 4, AUX IN/
MONITOR IN and STEREO LINK IN) may be low.
If this happens, use connection cables that do not contain resistors.
* Howling could be produced depending on the location of
microphones relative to speakers. This can be remedied by:
1. Changing the orientation of the microphone.
2. Relocating microphone at a greater distance from speakers.
3. Lowering volume levels.
STEREO
LINK OUT
STEREO
LINK IN
Foot switches
KC-880
Mic
Headphones
Portable
audio
player
Rhythm machine Electronic
drum
Sound module
Digital piano
Synthesizer
CD player
PA system Recorder
White Red White Red
FS-5L FS-5L FS-6
PCS-31 PCS-31
* For information on the switch settings, refer to page 12.
KC-880_e.book 9 ページ ２００９年１月６日 火曜日 午前１０時２６分