Using the tv, Tv channel setting – RCA SPS36123 User Manual

Page 24

USiNG THE TV

Connect a TV antenna or CATV cable or Satellite system to the TV antenna terminal before scanning

for TV channels

Scanning for Tv Channels Automatically (Only appears to the first time power on)

1. Connect the TV antenna.
2. Connect the AC power cord.
3. Press the

ON/Off button to turn on the unit.

4. Press the

DVD/TV/RADiO button (the fUNCTiON button on

the remote control) to select TV mode.

5. Press the button to select “Yes”.
6. Press the

ENTER button.

7. Press the

or button to select Antenna.

8. Press the or button to select Air.

9. Press the

or button to select Auto Scan.

10. Press the button to enter.
11. Press the /

ENTER button.

12. The unit will immediately search all channels for those with

adequate signal strength and store those channels with
signals in memory. The unit will take a short minutes to finish
auto scan and after this is completed, the unit will switch to
the first channel found.

MENU

Retur

"ENTER"

Adjust

Select

RF CH

Found

Picture

Audio

Time

Setup

Parental

Tv Channel Setting

1. Press the

TV MENU button.

2. Use the or button to select TV.
3. Use the or button to select the options

(Antenna / Auto

Scan / Auto Scan Add CH / Channel Skip / Channel No. /

Channel Label / DTV Signal).

4. Use the or button to make adjustment. The screen will

change to your selected mode immediately. Press the

MENU button to return to the previous menu.

5. Repeat steps 2 to 4 to adjust other options.
6. To exit the MAIN MENU and return to the normal screen, press

the

EXiT button on the remote control.

NOTE: Channel No. : 2-69 Channel for Air, 1-135 Channel for

Cable.
Antenna :

Select “Cable” to receive cable signals. Select “Air” to receive “over the air” (broadcast)
signals.

Auto Scan :

Automatically scan all channels for those with adequate signal strength.

Auto Scan Add CH: The already-stored channels will not be cleared and the newly-scanned channels will

be added.

If you have selected Cable in Antenna, then you can select Cable System (AUTO / STD / HRC / IRC) in the
submenu. We recommend you pick “AUTO”. “HRC” and “IRC” are custom station frequencies used by some
Cable Service Providers. “STD” refers to the standard frequencies used by many Cable Service Providers.
“AUTO” will cause the product to scan all frequencies.
Channel Skip:

You may switch ON/OFF the skip function of each stored channel by selecting the
channel with or button (and using or button to select page if the amount
of stored channels is more than 1 page), and followed with pressing the

ENTER

button.

Channel No.:

Select a different TV channel.

DTV Signal:

Display the signal strength (for digital TV channels only).

MENU

Return

Adjust

Select

Antenna

Air

Auto Scan
Auto Scan Add CH
Channel Skip
Channel No.
Channel Label
DTV Signal

Picture

Audio

Setup

Parental

Time

RCA SPS36123 Eng IB W011.indd 24

8/18/2009 4:29:59 PM