Roland VP-7 - Manual (Page 28)

28
Performing along with
Your Portable Audio Player
You can perform along with sound from your portable audio player, CD player, sampler, or other external device.
For example, you could have an accompaniment be played by your portable audio player while you use a microphone or key-
board to perform using Human Voice or Vocal Designer.
Connecting your portable audio player
1. Connect your portable audio player or other device to the LINE INPUT jack located on the VP-7’s rear panel .
926a
* When connection cables with resistors are used, the volume level of equipment connected to the input (LINE INPUT) may be
low . If this happens, use connection cables that do not contain resistors .
* To prevent damage to your speakers or other equipment, make sure to turn down the volume on all devices before you
make any connections .
Portable audio player
LINE INPUT
(Stereo miniature phone type)
Audio
Cable
Adjusting the volume
1. Switch off the power to your portable audio player and other devices, then raise the volume so it’s at an ap-
propriate level .
2. While playing the VP-7, adjust the volume of your portable audio player so it’s at an appropriate level .
The sound from the portable audio player that’s connected to the LINE INPUT jack will be output as is from both the OUTPUT
jacks and the Headphone jack.
NOTE
• The input level of the LINE INPUT cannot be adjusted on the VP-7 itself.
• The [Bypass] button, [Harmony] knob, and [Ambience] knob do not affect the LINE INPUT.