Runco SP-42 - Manual (Page 52)

Operation
42 Runco CinemaWall SP Series Owner’s Operating Manual
PRE
L
IMINAR
Y
Time/Date: Select Time/Date from the Option menu to set the CinemaWall’s internal
clock (time of day and day of the week) and turn the screen maintenance feature on or off.
• Present Time: To set the internal clock, highlight Present Time and press SET.
Then, use the right- or left-arrow buttons ( , ) to set the time. Press SET again
when you are finished.
• Program Timer: Set Program Timer to ON to enable the CinemaWall’s screen
maintenance feature, which lets you replace the normal source signal with a white field,
an inverse image or an “orbiting” image. This occurs according to the schedule you
establish using the Screen Maint. menu in Installer Adjust mode (refer to
Screen Maint. on page 43).
Select Return to exit the Time/Date menu.
PDP Mgmt: Select PDP Mgmt. from the Option menu to configure the image burn-in
prevention settings on the CinemaWall.
• Orbiter: Select Orbiter from the PDP Mgmt. menu to set the picture shift.
• OFF: Orbiter mode does not function.
• TYPE 1: The image size is reduced so the entire image remains in the display area
while orbiting.
• TYPE 2: The image is enlarged so there are no black bands in the display area while
orbiting.
• TYPE 3: The image size is unchanged.
• Soften: Select Soften from the PDP Mgmt. menu to reduce edges (color transitions)
and soften the image.
• OFF: Turns the SOFTEN function off.
• 1, 2, 3, 4: Activates the SOFTEN setting. Higher numbers create a “softer” image.
Auto Setup Mode: The CinemaWall can automatically adjust the position, frequency and
phase of incoming computer signals for optimum picture quality whenever the display is
turned on, or when a different input or input signal type is selected. To enable this feature,
select Auto Setup Mode from the Option menu and set it to ON.
1. When TYPE 1 or TYPE 2 is selected, the image movement is
continuous; TYPE 3 causes the image to move one pixel at a
time.
2. The Orbiter does not function while the MAGNIFY feature is in
use.
Under some conditions – such as when the input signal consists of
mostly dark colors – Auto Setup may not produce the desired
results. If this occurs, set Auto Setup Mode to OFF and manually
adjust the image position, frequency and phase; refer to Screen on
page 38.
Note
Note