Ricoh IS450 User Manual
Page 18
1. Introduction
4
TH2H020E
1. White Sheet
This presses the document down on the
contact glass.
2. Contact Glass
This is where the document is placed.
3. ADF Cover
Open this cover to clear paper jams, etc.
4. Power Connector
Connect the power cable here.
5. Rotary Switch
This switch is used to set the SCSI ID.
6. SCSI Connector
Connect the SCSI interface cable here.
7. Interface for Reverse Side Scan-
ning
This is an extension interface for reverse
side scanning. (Duplex Model only)
8. DIP Switches
These switches are used to set the operat-
ing mode.
9. Reset Switch
This switch resets the scanner as if the
power had been turned off and then back
on again. This switch is used to make
new DIP switch and rotary switch set-
tings valid.
1
2
3
4
5
6
78 9