RoyalTek RBT-2300 - Manual (Page 8)

8
When Memory full, the GPS Green LED is off.
2.4.5. Memory Status LED (Red)
Glowing – Memory is full.
RED LED blinking when erasing memory data.
2.4.6. Battery Status LED (Amber/Yellow)
None - Battery has adequate power supply.
Amber - Power is low. Charging immediately is required.
Yellow - Connected to power charger, charging.
LED off - Battery is fully charged.
2.5. Getting Started
2.5.1. STEP 1: Charge the Battery
Before you use RBT-2300, the battery must be charged for at least
4 hours. Plug car charger into power jack and cigar-lighter
separately. As RBT-2300 is in charging, the Yellow LED will be
lighted up. When the battery is fully charged, the Yellow LED will be
turned off. Unplug car charger from power jack and cigar-lighter
separately.
2.5.2. STEP 2: Turn on Receiver and Wait for GPS
Fix
If the position has not been fixed yet, the Green LED will be still. If
the position has been fixed, the Green LED will be Glowing.
You are ready to connect to your Bluetooth-enabled mobile device
and use your GPS application.
2.5.3. STEP 3: Connect to Bluetooth-Enabled
Devices
From your Bluetooth-enabled handheld device, execute Bluetooth
application software to search RBT-2300 and then connect it to
your device. If the connection between your device and RBT-2300
is successful, the Blue LED will be Glowing.
Note: Type in pin code=0000 during configuration.