Rimage 480i - Manual (Page 27)

Maintain the Rimage 480i Printer
Replace Consumables
This section provides information about how to replace the consumables on the Rimage 480i printer . The
consumables for the 480i printer include:
y The fan filter
y The ink cartridges
Replace the Fan Filter
You must change the fan filter every month. Use this procedure to change the fan filter.
1. Use a small screwdriver to gently pull the fan
grating away from the Rimage 480i printer. The
fan grating and fan filter easily come off the filter
housing.
2. Remove the old fan filter.
3. Place the new fan filter in the filter housing.
4. Gently press the fan grating into the Rimage
480i printer until it snaps into place.
Fan
Filter
Fan
Grating
Replace the Ink Cartridges
Use this procedure to change the ink cartridges on your Rimage 480i printer.
-
Important! You must use the appropriate ink cartridges in one of the configurations listed in the
Ink Requirements section. Refer to page 5.
1. Lift the ink cartridge access door. The ink cartridge carriage moves to an accessible position on the
carriage guide.
2. When the ink cartridge carriage stops, lift the
ink cartridge latch to the open position.
3. If an ink cartridge is already installed, slide the
ink cartridge out of the ink cartridge cradle.
4. Remove a new ink cartridge from the
packaging.
5. Carefully remove the protective tape that
covers the ink nozzles.
-
Important! Do not touch the nozzles or the
copper contacts on the ink cartridges. If
you touch these parts, clogs, ink failure,
and poor electrical connections are likely to
occur. Do not remove the copper strips.
6. Hold the ink cartridge so that the copper strip
is on the bottom and faces toward the printer.
7. Slide the ink cartridge into the cradle.
8. Push down on the ink cartridge latch until it snaps closed.
Ink Cartridge Latch
110761_D 23