RCA F19436 - Manual (Page 20)

Connections & Setup
18 Chapter 1
Tip
Leave your cable box turned ON to download
program information.
Leave your VCR turned OFF to record programs.
4. Look at the front of your VCR. If your VCR turned on
automatically and changed to channel 09, the test
was successful. Highlight Yes and press OK.
If your VCR didn’t change to channel 09, you can
either choose No or Test this code again.
If you think your TV or remotes might have been
touched during the test, tune your VCR to channel 02,
turn off your VCR and highlight Test this code again.
If you don’t think the test was interrupted, highlight
No. Tune your VCR to channel 02 and turn off your
VCR. Press OK (the GUIDE Plus+ system starts testing
another set of codes.)
Keep following the previous instructions until the
VCR finds the correct code.
Note: If the GUIDE Plus+ system can’t locate
the correct code for the VCR, a list of
troubleshooting instructions appears to help
you before you try again.
• Try VCR configuration again: repeat VCR
setup.
• Test alternate codes: tests selected brands and
if this fails, the test continues with all codes in
the system.
• Skip this step: the GUIDE Plus+ system
won’t be able to automatically schedule
programs to record on your VCR.
Step 4: Confirming Your Settings
1. Check to make sure all settings are complete and
correct. If all settings are complete, highlight Yes, end
setup and press OK. If your cable box and/or VCR
code testing failed, you should see INCOMPLETE
where the cable box and VCR codes are listed. Once
setup is complete, additional screens appear.
If any settings are incomplete or incorrect, highlight
No, repeat setup process and press OK. Follow the
instructions on the screen.
2. You can choose to view a demo of the GUIDE Plus+
features, which may take a few minutes to load. If
you don’t want to see the demo right now, press OK
to watch TV.
1571963A.01 Setup 4/9/02, 12:58 PM 18