Radio Shack PRO-29 - Manual (Page 20)

20
Limit Search
A limit search lets you search for active frequencies between upper and
lower limits that you set.
-L- appears on the display during a limit
search.
1. Press PROGRAM , then LIMIT . Lo appears on the display.
2. Enter the lower limit of the frequency range you want to search.
3. Press WX/E , then LIMIT . Hi appears on the display.
Note: If the frequency you entered is not a valid frequency,
Error appears. To enter a different frequency, start again from
Step 2.
4. Enter the upper limit of the frequency range.
5. Press WX/E , then LIMIT. Lo and the lower limit frequency appear
on the display.
6. Press t to search from the upper to the lower limit, or s to search
from the lower to the upper limit. The current monitor memory
number starts flashing at the top of the display.
7. When the scanner stops on a transmission you want to save,
press MONITOR to store the frequency in the current monitor mem-
ory. The monitor number then stops flashing.
8. Press either t or s to continue the search. If you saved a frequency
in a monitor memory, then the monitor memory number on the dis-
play advances by one and starts flashing again. (If the last monitor
memory was 6, the scanner returns to monitor memory 1.)
9. To hold the frequency, press LIMIT . -H- appears on the display.
To exit the hold mode and resume the limit search, press LIMIT
again.
Notes:
• You can press t or s during the hold mode to step through the
frequencies toward the upper or lower limits.
• If you tune to a search skip frequency, the display shows L/O
(see “Search Skip Memory”).
20-509.fm Page 20 Wednesday, August 4, 1999 1:58 PM