RuggedCom RS416 - Manual (Page 15)

Installation
15
RuggedCom ® RuggedServer™ RS416 Family Installation Guide rev118
2.2 Power Supply Wiring and Grounding
The RS416 supports dual redundant power supplies – “Power Supply 1 (PS1)” and
“Power Supply 2 (PS2)”. RS416P features a universal high voltage range power supply
as PS1, and a separate 48VDC supply, PS2, to provide Power over Ethernet. The
connections for PS1, PS2 and the fail-safe relay are located on the terminal block as
shown in Figure 6 and Figure 7.
Figure 6: RS416 Series Phillips Screw Terminal Block
Figure 7: RS416 Series Phoenix Plug Terminal Block
The RS416 Family chassis ground connection, shown in Figure 8, uses a #6-32 screw. It
is recommended to terminate the ground connection in a #6 ring lug, and to use a torque
setting not exceeding 15 in.lbs (1.7 Nm).
Figure 8: Chassis Ground Connection
The RS416 can be equipped with either a Phillips Screw Terminal Block or a Phoenix
Plug Terminal Block. The Phillips Screw Terminal Block has Phillips screws with a
#6-32 screw with
ext. washer.
#6 ring lug
stainless steel standoff
Philips Screw Terminal without Cover Philips Screw Terminal with Cover
Safety Cover
Safety Cover
Screws
Chassis Ground
Connection
Surge / Chassis
Ground Jumper
Terminal
Phoenix Plug Terminal without Cover Phoenix Plug Terminal with Cover
Safety Cover
Screws
Safety Cover Chassis Ground
Connection
Terminal Surge / Chassis
Ground Jumper