Radio Shack ET-542 - Manual (Page 13)

13
Storing a Number in Memory
1. Press MEMORY .
Note: While you are storing a
number in memory, if you do not
press any button on the keypad
within about 10 seconds, a buzz
sounds. You must start the pro-
cess over from the beginning.
2. Dial the phone number you want
to store.
3. Press MEMORY again.
4. Press the memory location num-
ber ( 0 - 9 ) where you want to store
the number. A long beep sounds.
The phone number is now stored
in memory.
5. Pull out the memory index card
from the right side of the base.
Write the person’s or company’s
name and memory location num-
ber on the card in pencil (in case
you want to store a different num-
ber later).
6. Repeat Steps 1-5 to store other
telephone numbers.
Notes:
• If you receive a call while you are
storing a number in memory,
press
TALK to answer the call.
After the call, begin again at Step
1 to store the number.
• To change a number stored in
memory, simply store a new num-
ber in that memory location.
• To clear a memory location so no
number is stored there, press
MEMORY twice, then press the
memory location number. A long
beep sounds. The number is now
cleared from memory.
If a buzz sounds, you did not suc-
cessfully clear the memory loca-
tion. Try the process again.
illustration
illustration
43-1042.fm Page 13 Tuesday, August 17, 1999 10:28 AM