Radio Shack ET-542 - Manual (Page 12)

12
USING TONE SERVICES
ON A PULSE LINE
Some special services, such as bank
by phone, require tone signals. If you
have pulse service, you can still use
these special tone services by follow-
ing these steps.
1. Set TONE/PULSE on the base to
PULSE .
2. Dial the service’s main number.
3. When the service answers, press
TONE/ on the keypad. Then dial
the additional numbers. The
phone sends these numbers as
tone signals.
4. When you complete the call, place
the handset on the base or press
TALK to disconnect the call. The
phone automatically resets to the
pulse mode.
USING PAGE
The PAGE feature lets you send a
page from the base to the handset, so
you can page someone at the handset
or locate it if you misplaced it.
When the handset is not in use and
someone presses
PAGE on the base,
the handset beeps three sets of two
beeps. The
TALK light on the handset
and the IN USE/CHARGE indicator on
the base flash.
Note: The handset will not beep dur-
ing a call.
MEMORY DIALING
You can store up to 10 numbers for
two-button dialing. Each stored num-
ber can be up to 16 digits long.
Notes:
• Do not store a number with both
pulse and tone entries in the same
memory location. This could result
in a wrong number being dialed.
• If TONE/PULSE is set to PULSE
and you want to use tone dialing
for a memory number, store the
tone entry (
TONE/ ) in the next
memory location.
• To keep your accounts secure, we
recommend you do NOT store
your personal access code for
services such as bank-by-phone
in a memory location.
illustration
43-1042.fm Page 12 Tuesday, August 17, 1999 10:28 AM