Runco REFLECTION VX-1000CI - Manual (Page 30)

28
COMMAND PARAMETER (min/max) Value stored? DESCRIPTION
ON NA NA Turns PFP Controller on
OFF NA NA Turns PFP Controller off
COMPOSITE NA YES Selects the Composite video
input
SVIDEO NA YES Selects the S-Video input
COMPONENT NA YES Selects the Component input
HDRGB NA YES Selects the RGB HD input
HDCOMPONENT NA YES Selects the Component HD input
DVI NA YES Selects the DVI input on the
Projector
ANAMORPHIC NA YES Selects the anamorphic
aspect ratio
STANDARD NA YES Selects the standard (4:3)
aspect ratio
LETTERBOX NA YES Selects the letterbox aspect ratio
VIRTUALWIDE NA YES Selects the VirtualWide aspect
ratio
TINT -127/127 (HD-30/30)* NO Sets a value for tint
COLOR -127/127 (HD-30/30)* NO Sets a value for color
AGCCOLOR 0/1 NO 0=Disable Color AGC
1=Enable Color AGC
BRIGHTNESS -30/30 NO Sets a value for brightness
CONTRAST -30/30 NO Sets a value for contrast
AGCCONTRAST 0/1 NO 0=Disable Contrast AGC
1=Enable Contrast AGC
SHARPNESS 0/255 (HD-30/30)* NO Sets a value for sharpness
CHROMAHIGH 0/127 NO Sets a value for high-frequency
chroma edge enhancement
CHROMALOW 0/127 NO Sets a value for low-frequency
chroma edge enhancement
LUMAHIGH 0/127 NO Sets a value for high-frequency
luminance edge enhancement
LUMALOW 0/127 NO Sets a value for low-frequency
luminance edge enhancement
TEMPERATURE 55/115 NO Selects the Projector’s color
temperature
RS-232 Commands
* These parameters are applicable only in the HD Component mode.