Roberts Radio R9943 - Manual (Page 8)

7
Operating you radio
Your radio is equipped with four tuning methods:- Scan tuning, Rotary
tuning, Manual tuning, and Memory preset tuning. When switched on
your radio will display the waveband and frequency in use. A graphical
display similar to a conventional radio tuning dial will be shown in the
bottom half of the display.
Scan tuning
1. Press the On/Off button to switch on your radio.
2. Select the required waveband by repeatedly pressing the Band
button. For the FM waveband fully extend the Telescopic aerial
angle and rotate, if necessary, to obtain best reception.
3. Press and hold down either the Tuning up or Tuning down buttons
for more the 0.5 sec to commence scan tuning.
4. Your radio will scan the selected waveband and stop automatically
when it finds a station of sufficient strength. The tuning indicator
and station frequency will appear in the display.
5. To recommence scan tuning, press and hold down either the
Tuning up or Tuning down buttons for more the 0.5 sec.
6. When the waveband end is reached the radio will bleep and continue
tuning from the opposite waveband end.
7. Set the Volume control and Tone controls to the desired settings.
8. To switch off your radio press the On/Off button.