Roland COLORCHOICE - Manual (Page 24)

24
Defines the number of times to print the same image superimposed over the same position. The default
is one.
Page Spacing
You can specify the margin between pages. By specifying ‘0mm’, you can connect two or more pages.
Media Feed Calibration
Check “Media Feed Calibration” to print in accurate distances. If you manually calibrate, via the Setup
menu, uncheck this checkbox.
Cut Media After Printing
Check “Cut Media After Printing” To separate the sheet after printing is complete.
Dry Time (CAMM JET Only)
Defines the Ink Drying time. When performing Print and Cut, it will wait the specified amount of time
before cutting. Set longer interval when using media that does not absorb the ink well.
Print Crop Mark (CAMM JET Only)
When this option is checked, the printer will add automatically a crop mark to the output. This option has
the same effect with the setting done in the printer panel (CROP MARK - ENABLE).
By adding the crop mark to the output, you can take out the print from the printer, then set it back and
perform the contour cut with correct alignment. Please consult "User's Reference - Remove the Printed
Material, then Reload the Material and Perform Cutting - Setting the Base Point and Align Point" in the
CAMM JET User's Manual for more information.
See the procedures below to print, laminate then cut a design file with Print and Cut data.
Select "Print Only" for the "Send" mode in General tab. Open the Print tab and click on the Driver Option
button to display the Driver Options dialog. Check the "Print Crop Mark" option. After these settings,
CAMM JET will print only adding the crop mark to the output.
Remove the print out from the printer and laminate it. Follow the instructions from the section "User's
Reference - Remove the Printed Material, then Reload the Material and Perform Cutting - Setting the
Base Point and Align Point" in the CAMM JET User's Manual to set the media back in the printer, and
adjust the base point and the alignment based on the crop mark.
Then choose "Contour Only" for the "Send" mode in the General tab. Open the Print tab and click on the
Driver Options button to display the Driver Options dialog. Uncheck the "Print Crop Mark" option. After
these settings, CAMM JET will only process the contour cut.
Driver Options (ColorCAMM)
Clicking this button launches the Driver Options dialog, shown below.
Print Order
You can set several modes concerning how the ribbons will be used during the printing process.
Process Color Order
Here you can select the order that the ribbons will be used during printing. You can set the print order for
each color mode (CMY, CMYK, CMYKOrGr).
Print White Color First
When this option is checked, the white color will be printed first using the white ribbon and then the
process colors and spot colors will be printed.
Mirror Printing Order
When this option is checked, the order of the ribbons will be inverted. This feature should be used to
print in transparent films. Notice that the image itself will not be inverted. To invert the image, you have
to use the Mirror button on Job Properties.