Ricoh DDST A - Manual (Page 41)

The Printer Function
35
5
NV-RAM Error An error has occurred in the
printer. Turn off the main power
switch, and back on again. If
the message appears again,
contact your sales or service
representative.
Output Tray changed. The output tray has been changed
because of the paper size limita-
tion of the selected tray. Select the correct output tray.
Paper size/type mismatch.
Change settings to:
xxx yyy
There is no paper tray that
matches the paper settings se-
lected under Auto Tray Select.
xxx indicates the tray number.
yyy indicates the paper size
and the paper type.
Press [JobReset] to change the
paper tray settings, or press
[FormFeed]
to print regardless.
For details about the paper
tray settings, see General Set-
tings Guide.
[Print] without below
mode?
This is an alert message con-
cerning a paper tray in auto
tray select. Press [Print] to cancel the mode
and print the job.
Printer Font Error An error has occurred in the
font file. Turn off the main power
switch, and back on again. If
the message appears again,
contact your sales or service
representative.
Print overrun. The image data has been
thinned out due to image com-
pression. Increase memory capacity.
When installing a memory
module in the machine, con-
tact your sales or service rep-
resentative.
Paper Tray is in use. The specified paper tray is in
use by another function, such
as the copier function. Wait until the other function
has finished using the speci-
fied paper tray.
Reset Paper Tray correctly. The selected paper tray does
not exist or is not set correctly. Set the paper tray correctly.
DToner is almost empty
Add toner Toner is running out. Replace the toner cartridge
soon to prevent poor print
quality.
Tray # Error An error has occurred with the
paper tray.
# indicates the tray number.
Press [JobReset] to change the
paper tray settings, or press
[FormFeed]
to select another
paper tray and print.
Unauthorized user access. Print job canceled due to user
restrictions. Check the User Code permis-
sion status.
USB has a problem An error has occurred in the
USB interface. Turn off the main power
switch, and back on again. If
the message appears again,
contact your sales or service
representative.
Messages/Second messages Causes Solutions