Radio Shack TAD-1024 - Manual (Page 16)

16
CHANGING THE REMOTE
OPERATION SECURITY
CODE
The remote operation security code is
preset to 784, but you can change it by
following these steps.
Note: Be sure to set each digit within 8
seconds. Otherwise, you must start over
from Step 1.
1. Hold down CODE/SKIP until the TAD
beeps once. Co appears.
2. Press CODE/SKIP again. Sc (securi-
ty code) and the digits of the current
code appear in sequence, then the
first digit reappears.
For example, when the security
code is 784, the display shows
Sc
(security code), –7 , –8 , – 4 , then –
7 reappears.
3. Repeatedly press SKIP/CODE or
MEMO/REPEAT to set the first digit,
then press ANSWER . The second
digit appears.
Note: If you enter an incorrect digit,
press
STOP/TIME SET , then repeat
the procedure.
4. Press SKIP/CODE or MEMO/REPEAT
to set the second digit, then press
ANSWER . The third digit appears.
5. Press SKIP/CODE or MEMO/REPEAT
to set the third digit, then press AN-
SWER . The TAD sounds a long
beep.
To check the remote operation security
code at any time, follow Steps 1 and 2,
then press
STOP/TIME SET to exit.
43-784.fm Page 16 Monday, August 16, 1999 7:47 AM