Radio Shack TAD-1024 - Manual (Page 12)

12
SCREENING CALLS
To screen calls, let the TAD answer
them, then listen to the caller’s message
through the TAD’s speaker. If you de-
cide to answer the call, pick up any
phone on the same phone line as the
TAD. The TAD stops recording and re-
sets to answer the next call.
Note: If you pick up the phone just as the
TAD answers, the TAD might not stop
playing the outgoing message. If this
happens, press on the phone or
STOP/
TIME SET on the TAD.
If you do not want to take the call, do not
pick up the phone, and let the TAD finish
recording the caller’s message.
To adjust the volume, rotate VOLUME
on the side of the TAD.
PLAYING MESSAGES
The display shows the total number of
messages. If there are new messages,
the power indicator also flashes until all
new messages have been played.
To play all the messages (old and new),
press
PLAY . The TAD announces the
number of messages recorded, each
message number and the day and time
the message was recorded, and then
plays the message.
To play only new messages, hold down
PLAY for 2 seconds. (If there are no new
messages stored, the TAD says, “You
have no new messages.”)
To adjust the volume, rotate VOLUME
on the side of the TAD.
After all messages play, the TAD says,
“End of message(s)” and saves all the
messages.
To replay a message while you are lis-
tening to it, press
MEMO/REPEAT . The
current message starts again from the
beginning.
43-784.fm Page 12 Monday, August 16, 1999 7:47 AM