Raypak 185A User Manual
Page 10
GASKET & NEW CIRCUIT BOARD NEW BEZEL INSTALLATION - MODELS 206A, 207A,
266A, 267A, 336A, 337A, 406A, 407A:
Make sure the power and gas are off.
Note: Disregard window gasket installation if already present.
1. Remove backing on gasket and install adhesive side on the control panel bezel
as shown in Fig. 24 & Fig. 25.
2. Re-assemble with new board to plastic bezel using the three mounting screws
as shown in Fig. 26.
RE-ASSEMBLE WITH NEW BOARD
MOUNTING SCREWS
Fig. 26
2151 Eastman Ave., Oxnard, CA 93030 805-278-5300 Fax 800-777-7026
www.raypak.com
Technical support is available M-F, 5:30 AM to 5:00 PM PST, at 800-947-2975 or 800-627-2975
LAY BEZEL
DOWN
Fig. 25
CLEAR
WINDOW
GASKET
ADHESIVE SIDE TO
PLASTIC BEZEL
REMOVE BACKING
Fig. 24
P/N 241169 Rev.-3
NOTE: DO NOT
RE-INSTALL
SCREW HERE
Page 10
- 902B (5 pages)
- Hi Delta 992B-1262B (66 pages)
- CHX (4 pages)
- R265B (7 pages)
- 406A (55 pages)
- 752B (8 pages)
- P-1223 (4 pages)
- RHP160 (2 pages)
- CR24-185 (8 pages)
- 206A (55 pages)
- 207 (4 pages)
- 6200.90 (1 page)
- Finned Water-Tube Pool Heaters 2072B-2342B (5 pages)
- P-4001 (38 pages)
- VERSA 105 (2 pages)
- MVB 504 (8 pages)
- RAYTHERM P-2100 (36 pages)
- CR406A (2 pages)
- RP2100 (52 pages)
- 402B (2 pages)
- 105A (4 pages)
- 2072B (7 pages)
- Versa 155 (2 pages)
- HI DELTA 2002B (3 pages)
- 538 To 4224 (18 pages)
- Versa 105B (32 pages)
- D-2 POWER VENT 206A (20 pages)
- Raytherm 514-824 (2 pages)
- Hi-Delta Commercial Swimming Pool Heater (1 page)
- 1802B-2342B (2 pages)
- C-R185B To P-R405B (52 pages)
- Commercial Cold Water Start (5 pages)
- 624 (2 pages)
- PS-4 PS-8 (32 pages)
- 407A (6 pages)
- 105B (31 pages)
- 155C (34 pages)
- R410A (2 pages)
- VERSA 155C (35 pages)
- HI DELTA 122-322 (44 pages)
- P (1 page)