Regency L234-NG - Manual (Page 14)

Regency ® L234 Direct Vent Gas Insert 14
INST
ALLA
TION
CONVERSION KIT #536-969 FROM NG TO LP
INSTALLATION
LP Conversion Kit Contains:
Qty. Part # Description
1 910-037 LP Pilot Orifi ce
1 904-163 Orifi ce #54
1 904-529 5/32" Allen Key
1 918-590 LP Conversion Decal
1 908-528 Red Propane Label
1 918-688 Instruction Sheet
THIS CONVERSION MUST BE DONE BY A QUALIFIED GAS FITTER, IF IN DOUBT DO NOT DO THIS CONVERSION!!
LP Conversion instructions for BEFORE UNIT INSTALLATION.
1) Open the left and right side faceplate
panels.
2) Turn off the gas supply.
3) Remove the bottom louver by pulling out.
4) Remove the glass door.
a) Pull off the left side spring hook that
holds the door in place. While holding the
hook turn it upside down and place it into
the middle opening on the top side mounting
bracket. Repeat for right side
.
b) Swing the door out 45 degrees and lift up
and out.
5) Remove the logs if installed.
6) Remove the brick panels if installed.
7) Remove the burner by undoing the 3
screws.
Burner Removed
8) Remove the burner tray by undoing the 4
screws.
Burner Tray Removed
Spring Hook
Top Mounting Bracket