Radio Shack ET-596 - Manual (Page 8)

8
5. Plug the other end(s) of the modu-
lar cord(s) into the modular
jack(s).
6. Raise the base’s antenna to a ver-
tical position and fully extend it.
Mounting the Base
on a Wall Plate
To make this connection, you need a
2-line short modular cord, such as
Cat. No. 279-390, not supplied.
1. If you have a single 2-line modular
jack on the wall plate, plug one
end of a 2-line short modular cord
into the
TEL LINE 1/2 jack.
Note: When you make this con-
nection, you should not connect
another modular cord to the
TEL
LINE 2 jack or phone operation will
be erratic.
If you have a single 1-line modular
jack on the wall plate and a modu-
lar wall jack close by, plug one
end of a 2-line short modular cord
into the
TEL LINE 1/2 jack to use
line 1, then connect the supplied
modular cord into the
TEL LINE 2
jack to use line 2.
If you have only one 1-line modu-
lar jack on the wall plate, plug one
end of a 2-line short modular cord
into the
TEL LINE 1/2 jack to use
line 1, or to the TEL LINE 2 jack to
use line 2.
43-696a.fm Page 8 Friday, August 13, 1999 12:48 PM