Radio Shack ET-596 - Manual (Page 10)

10
7. Raise the base’s antenna to a ver-
tical position and fully extend it.
Mounting the Base
Directly on the Wall
To mount the base directly on the wall,
you need two wood screws (not sup-
plied) with heads that fit into the key-
hole slots on the bottom of the base.
1. Drill two holes 3 15 /
16
inches apart.
Then thread a screw into each hole,
letting the heads extend about
5 /
16
inch from the wall.
2. If you have a single 2-line modular
jack close by, plug one end of the
supplied modular cord into the
TEL LINE 1/2 jack.
Note: When you make this con-
nection, you should not connect
another modular cord to the
TEL
LINE 2 jack or phone operation will
be erratic.
If you have two separate 1-line
modular jacks, plug one end of the
supplied modular cord into the
TEL LINE 1/2 jack and plug
another modular cord (not sup-
plied) into the
TEL LINE 2 jack.
If you have only one 1-line modu-
lar jack, plug one end of the sup-
plied modular cord into the
TEL
LINE 1/2 jack to use line 1, or to
the TEL LINE 2 jack to use line 2.
3 15 / 16
"
5 / 16
"
5 /
16
"
43-696a.fm Page 10 Friday, August 13, 1999 12:48 PM