Ryobi RPW2500WB - Manual (Page 9)

9
ASSEMBLY
WARNING:
If any parts are damaged or missing do not operate this
product until the parts are replaced. Failure to heed this
warning could result in serious personal injury.
WARNING:
Do not attempt to modify this product or create acces-
sories not recommended for use with this product. Any
such alteration or modification is misuse and could result
in a hazardous condition leading to possible serious
personal injury.
WARNING:
To prevent accidental starting that could cause serious
personal injury, always disconnect the engine spark plug
wire from the spark plug when assembling parts.
INSTALLING THE HANDLE BAR
See Figures 2 - 3.

Remove the acorn nuts and handle knobs from frame.
 Retract handle bolts until end of bolts are flush with handle
spacers.
 Install handle bar as shown. Handle bar should rest in
grooves of spacers and holes in handle bar should align
with handle bolts.
 Press handle bolts through openings in handle bar.
 Re-thread knobs on handle bolts and tighten to secure.
 Re-thread acorn nuts on end of handle bolts and tighten
with wrench (not provided).
 Place spray wand into storage clips located on the side
of handle bar.
Fig. 2
Fig. 3
ACORN
NUT
HANDLE BOLTS RETRACTED
UNTIL FLUSH WITH SPACER
HANDLE BAR
HANDLE
SPACERS
HANDLE
KNOB
SPRAY WAND
STORAGE CLIPS