Ryobi RPW2500WB - Manual (Page 10)

10
ASSEMBLY
INSTALLING TRIGGER HANDLE HOLDERS
See Figures 4 - 5.

Place top trigger handle holder over handle bar and align
holes.
 Secure using screws and nuts as shown.
 While holding screw with Phillips screwdriver, tighten each
nut with wrench to secure.
 Repeat process to install bottom trigger handle holder.
 Clip flat area of trigger handle into top holder and bottom
ribbed area of trigger handle into bottom holder. Slide
forward until trigger handle rests securely in holders.
 Rotate trigger handle so that bottom edge of handle snaps
into handle lock.
ASSEMBLING THE SPRAY WAND
See Figure 6.

Insert the end of the spray wand into the trigger handle
outlet coupler as shown in figure 6 and push together
until coupler snaps into place.
Fig. 5
Fig. 4
HANDLE
LOCK
TOP TRIGGER
HANDLE HOLDER
BOTTOM TRIGGER
HANDLE HOLDER
Fig. 6
SPRAY
WAND
OUTLET
COUPLER
TRIGGER
HANDLE
RELEASE