RAD Data comm BR-ASI01 - Manual (Page 32)

32
Frame Relay DLCI Mappings
If you are connecting to another DCB router, this information is not required. DCB
uses IARP (Inverse Address Resolution Protocol) to dynamically generate this
information. To connect to other vendors’ routers which do not support IARP, or
do not have it turned on, you must provide DLCI to protocol mapping information.
RV: Use the DLCI Mapping Database window.
CL: Use interface(misc) and then frelay(set).
Physical Comm Settings
You may need to set the baud rate, sync/async operation, and other physical
communications parameters for the WAN port. These parameters will depend on
the line communications device you are using.
RV: Use the WAN/General window.
CL: Use interface(misc) and then wan serial(set).