RAD Data comm BR-ASI01 - Manual (Page 25)

25
AppleTalk Protocol
Required for AppleTalk
There are generally no required changes from the shipping Ethernet configuration
for AppleTalk. The Ethernet port will autoconfigure to use AppleTalk Phase II, and
will autoadapt to conditions on the Ethernet.
Suggested for AppleTalk
You may want to set your own network numbers, rather than using the
autoconfigured values. You may also want to use more meaningful zone names.
RV: Use the Ethernet/AppleTalk screen.
CL: Use interface(misc) and appletalk(set).
DECnet Protocol
Required for DECnet
The router’s shipping configuration does not have DECnet turned on. You must
turn it on and set several DECnet parameters.
• Turn DECnet on
• Set DECnet area
• Set DECnet node
RV: Use the Main DECnet screen (All/DECnet).
CL: Use decnet(set).
Suggested for DECnet
Setting the parameters above should be adequate for most installations.
WAN Port PPP Configuration
This section covers the settings and software download required for PPP (point-to-
point) protocol operation of the BR Router WAN port.
The RS-232 WAN port on a BR Router can be run synchronously or
asynchronously, at rates up to 128Kbps (sync), or 115.2Kbps (async).