RAD Data comm BR-ASI01 - Manual (Page 30)

30
• IP Subnet mask
• IP Broadcast Address
RV: Use the WAN/IP screen to set these parameters.
CL: Use the interface(misc) and ip(set) commands.
Suggested for IP
These parameters help supply information about the segment that the port is
connected to. With this information, routing can take place.
• IP RIP (Routing Information Protocol)
and/or
• IP Static Routes
• IP Default Router
RV: Use the WAN/IP screen to set RIP, and the IP Static Routing Window (All/IP)
to set static routes and a default router.
CL: Use interface(misc) and then ip flags(set) to set RIP, and ip route(add) to add
static routes. User interface(misc) and ip(set) to set the default router.
IPX Protocol
Required for IPX
Frame Relay operation requires that the WAN port is set to be a “numbered
interface.” This means that the port (and thus the Frame Relay network) must have
an IPX network number.
• IPX numbered interface
• IPX Network Number
RV: Use the WAN/IPX screen.
CL: Use interface(misc) and then ipx(set).
Suggested for IPX
The settings above are all that is generally required for IPX operation over Frame
Relay.