Roberts Radio ecologic 5 User Manual

Page 14

Manual tune - FM

1. Fully extend the wire aerial located on the rear of your clock radio.

Place the wire antenna so that it is as straight as possible extending

either above or below the radio.

2. Press the On / Standby button to switch on your clock radio.

3. Press the Band button to select the FM band.

4. Press the Tuning Up or Down buttons to tune to a station. The

frequency will change in steps of 50kHz. Pressing and holding the

buttons will advance the frequency several times each second.

If the radio is tuned to a station of sufﬁcient signal strength with RDS

information present, then the display may change to show the station

name.

5. When the end of the waveband is reached the radio will recommence

tuning from the opposite end of the waveband.

6. Set the Volume to the desired setting.

7. To switch off your clock radio press the Standby button.

Note: The display will revert to a conventional time display 10 seconds

after the last button press except when displaying scrolling text.

2,7

TUNING

SNOOZE

down

VOLUME