2 selecting the input source, 3 setting the pc display properties, Selecting the input source – Runco PL-43DHD User Manual
Page 40: Setting the pc display properties, Iminar, Pre l iminar y
30
Runco PL-43DHD and PL-50DHD Owner’s Operating Manual
PRE
L
IMINAR
Y
4.2
Selecting the Input
Source
By default, the PlasmaWall is configured to display the signal received on its RGBHV
(ANALOG RGB IN) input. To use the DVI-D (DIGITAL RGB) input instead:
1. Press MENU and enter the Service Menu passcode.
2.
Select Service from the Main Menu.
3.
Select Display Device from the Service Menu.
4.
Press
to select DVI/HDMI, then press ENTER.
4.3
Setting the PC Display
Properties
To maximize image quality when using the PlasmaWall with a personal computer, you
may need to adjust the display properties of your PC video card. To do this:
1. Choose Settings from the Windows Start
menu and click on “Control Panel.”
2. Double click on the Display icon.
3. Click the Settings tab on the display dialog
box.
4. Adjust the resolution to 1024x768 or
1280x768 pixels.
You must enter a passcode to access the Service menu.
Note