Renesas M32192T2-PTC - Manual (Page 6)

(4/6)
5.2 For the M32100T2-SDI-E, M32100T3-SDI-E or
M32100T5-SDI-E
(1) Mount the NQPACK144SD-ND on the user system
(2) Connect the YQPACK144SD on the NQPACK144SD-ND.
(3) Secure the four corners of the YQPACK144SD with the
YQ-GUIDEs.
● Do NOT use the screws included with the
YQPACK144SD.
● Do NOT use the screwdriver included with the
NQPACK144SD-ND for fixing the YQ-GUIDEs. That
is used only for the HQPACK144SD.
(4) Set the clock select switch.
Refer to "6. Selecting a Clock" on page 5.
(5) Mount the M32192T2-PTC on the YQPACK144SD.
(6) Connect the emulator probe to the M32192T2-PTC.
.
Emulator main unit
or Emulator probe
Use a slotted screwdriver.
144-pin 0.5mm pitch
(144P6Q-A) foot pattern
(5)
(4) Clock select switch
(1)
(2)
(3)
(6)
M32192T2-PTC
YQPACK144SD
NQPACK144SD-ND
YQ-GUIDE(×4)
: No.1 pin
Be sure to match the position of No. 1 pin of
the foot pattern and each part.
Figure 5.2 Connection Procedure (2)
5.3 On-board Evaluation
(1) Mount the NQPACK144SD-ND on the user system
(2) Mount the M32192FxxFP on the NQPACK144SD-ND.
(3) Mount the HQPACK144SD on the NQPACK144SD-ND.
(1)
(2)
M32192FxxFP
NQPACK144SD-ND
HQPACK144SD
(separately available)
(3)
144-pin 0.5mm pitch
(144P6Q-A) foot pattern
: No.1 pin
Be sure to match the position of No. 1 pin of
the foot pattern and each part.
Figure 5.3 Connection Procedure (3)