RCA 42PA30RQ - Manual (Page 22)

Tuning To Analog Channels
An analog channel has a channel number beginning with “A”. Input the digital number with numeric buttons directly and press
ENTER button to confirm.
For example, to watch analog channel “A51”, press “5”, “1”, “ENTER” on remote control in sequence.
Adjusting TV Stand Angle
The TV cabinet can manually adjust to left or right for 15 degrees from the centre.
You can adjust the angle for the best viewing effect and comfort.
Tuning To Digital Channels
Note: Although there is no analog TV signal available in America, we reserve ATV functions for some expansible use.
A digital channel has a channel number beginning with “D”. Input the main digital number with numeric buttons directly, then press
“ ” button on remote control, and input the sub number at last.
For example, to watch analog channel “D31-1”, press “3”, “1”, “ ” button. “ENTER” on remote control in sequence.
You can use CH button to increase channel number and CH to decrease channel number. When no OSD (On Screen
Display) is used, the up/down arrows can also work as CH /CH buttons.
Press INPUT button on remote control to display Source Select list.
Use up/down arrows to highlight the source you need and press ENTER to confirm.
Changing Channels Directly
Basic Operations
Turning On and Off
Choosing TV Channel
Selecting Input Source
Connect the AC cord to power the TV. At this time the TV will enter standby mode and power indicator shows red.
Use Power button ( ) on the side panel of TV or on the remote control to turn on the TV. After switching off the TV for 5 seconds,
you can turn on TV again.
Source Select
TV
AV
Component 2
Component 1
HDMI 1
HDMI 2
HDMI 3
PC
21 English-