RCA HT35752BD - Manual (Page 6)

Other Connections to Back of Cabinet Area
4
➤ Make Other Connections to Back of Component Area
While you have easy access to the back of the audio/video component
cabinet, some additional connections should be made.
❑
1 . Identify cable TV and/or home antenna source(s). Connect the cable
TV or home antenna to the IN FROM ANTENNA OR CABLE connector
on the back of the jack panel extension cable. If necessary, use the 12’
RF cable packed in the accessory kit.
❑
2 . Extend the FM antenna shipped with the audio/video receiver to its
full length and attach it to the back wall frame. Run the antenna wire
through the fan’s power cord hole in the audio/video component
cabinet. Label the FM antenna wire. It will be connected to the
audio/video receiver later.
❑
3 . Attach the AM loop antenna shipped with the audio/video receiver to
the back of the audio/video rack as close as possible to the fan’s power
cord opening in the back of the cabinet. Run the antenna wire through
the fan’s power cord hole into the audio/video component cabinet.
Label the AM loop antenna wire. It will be connected to the
audio/video receiver later.
Caution: Before plugging in the power cord, make
sure the disconnect switch on the outside wall is off.
Leave the switch off until time to test the components.
❑
4 . Plug the 8’ power cord supplied in the accessory kit into the dedicated
duplex outlet and place it where it will be easily accessible after the
component and software rack is in place.