RCA SCENIUM HDLP50W151 - Manual (Page 45)

Using the TV’s Features
Chapter 3 43
Ch 88 -888 WWWW Antenna A (Air)
4:3 Normal 480i SD Listening to: English in SRS FOCUS
MPAA - Not Rated
60 60 - 2
Digital or Analog TV Channels
A single off-air antenna can pick up both analog and digital channels. Digital channels can be
made up of primary channels and subchannels.
Note: Subchannels (sometimes called minor channels) are channels associated with the
Primary channel (sometimes called the major channel). A primary channel may have just one
subchannel or multiple subchannels.
1. Make sure the TV is in TV mode by pressing TV on the remote
control.
2. Enter the primary channel number (up to three digits). This number
appears in the primary channel entry box. Press OK or wait a few
seconds. If you don’t enter a subchannel, the TV tunes to the lowest
subchannel.
3. If the primary channel number has fewer than three digits and you
want to enter subchannel numbers, press the right arrow button to
advance to the subchannel entry box.
4. Enter the number of the subchannel. This number appears in the
subchannel entry box.
5. Press OK to tune to the channel or wait a few seconds.
Notes:
You can always use the channel up and down buttons on the
remote control to change channels within the TV mode.
You may notice the size of the channel banner changes when you
change channels. This is perfectly normal and occurs because analog
(NTSC) broadcasts and digital (ATSC) broadcasts use different
formats. Your HDTV can display both types and adjusts the picture
accordingly.
If you wait too long before entering the subchannel, the TV tunes
to the lowest subchannel.
Tip
If a digital and analog channel have the same primary
channel number, tune to the analog channel by
entering the analog channel number or entering the
analog channel number and then a subchannel of “0.”
Primary
Channel Subchannel
(if necessary)
ON-OFF
TV
DVD VCR
AUX AUDIO SATCAB
CH. CTRL SKIP PIP SWAP
SOUND VCR PLUS+ FREEZE LIGHT
CLEAR
FORMAT INFO
MENU
GUIDE
OK
VCR+
TV Button
Right Arrow
Tip:
Use the channel banner to
determine whether a channel is
digital or analog. A digital (ATSC)
channel has a dash and second
number after it (e.g., 21-1); an
analog channel doesn’t (e.g., Ch 21).
1614682A.05_features_8.22 9/18/03, 5:29 PM 43