RCA SCENIUM HDLP50W151 - Manual (Page 35)

Chapter 2 33
Using the Remote Control
GUIDE Brings up the Listings screen for the GUIDE Plus+ system.
INFO Brings up the Channel Banner with channel and viewing information.
Press again to remove the banner. In the GUIDE Plus+ system, brings up more
program information.
INPUT Toggles through the TV’s available input sources (Front Input,
INPUT 1, INPUT 2, INPUT 3, INPUT 4, INPUT 5, DTVLink (if available), last-
active antenna).
MENU Makes Main Menu appear and disappear.
MUTE Reduces the TV’s volume to its minimum level. Press again to restore
volume.
OK When a menu item is highlighted, press OK to select the item.
ON•OFF Turns the TV on or off. Your HDTV is equipped with a special lamp
system. In order to preserve the life of the lamp, the TV must warm up and
cool down properly when you turn the TV on and off. When you turn the TV
off, the screen turns blue and fades to black. While the screen is blue, you can
still turn the TV back on. If the screen is black and the light on the front of the
TV blinks when you try to turn it on, the TV’s lamp is in its cool-down cycle—
wait about 30 seconds and then the TV will turn back on automatically.
In other modes (VCR, DVD, SAT/CAB, AUX, AUDIO), if programmed, turns the
component on and off.
Tips
The component button corresponding to the
mode you’re in flashes when the remote
batteries are low and you press a button on the
remote. A warning banner may also appear on
the screen when you press a remote button and
your batteries are low.
To turn off most RCA, GE, and Proscan
components that are connected to the TV, press
ON•OFF twice within two seconds and hold
remote steady until indicator turns off.
This feature only works with most RCA, GE, and
Proscan products.
PIP Makes the PIP window appear and disappear (See Chapter 3 for more information about using PIP.) Locks/unlocks
video window in GUIDE Plus+ system.
REVERSE, PLAY, FORWARD, RECORD, STOP, PAUSE If programmed, provides transport control for some remote-
controllable VCRs and DVD players. In TV mode, can control 1394 component when tuned to the 1394 input.
SAT/CAB Places the remote in SAT/CAB mode. If Auto Tuning is enabled, turns on the TV and tunes it to the correct
Video Input Channel.
SKIP Press once before changing channels and the TV returns to the original channel after 30 seconds. Press repeatedly to
add more time. Cannot be used with the browser. Use CLEAR to cancel.
SOUND On digital channels/inputs, toggles the audio language (if available for that channel). For analog channels, toggles
SAP on or off. Does not affect default menu settings for SAP or Audio Language.
SWAP When using PIP, switches the main picture with the PIP window.
TV Places the remote in TV mode. Turns on the TV and tunes to the last-viewed TV channel or input.
VCR Places the remote in VCR mode. If Auto Tuning is enabled, turns on the TV and tunes to the VCR Video Input
Channel.
VCR PLUS+ Only used with RECORD OUTPUT jacks. Press VCR PLUS+ to set a one touch recording when a VCR is
connected to the RECORD OUTPUT jacks—not a 1394 recording.
VOL – or VOL + Decreases or increases the TV’s volume. The TV Audio Output menu must be set to Variable Speakers On.
1614682A.04_8.25_remote 9/18/03, 5:33 PM 33