RIDGID DP15501 - Manual (Page 17)

17
ASSEMBLY
TO INSTALL THE LIGHT BULB
See Figure 13.
WARNING:
Failure to unplug drill press could result in
accidental starting causing possible serious
personal injury.
n Remove the amber colored lens cover by removing the
two Phillips screws.
n Install a light bulb (not larger than 60 watt) into the
socket inside the head.
n Replace the lens cover.
TO SQUARE THE TABLE TO HEAD
See Figure 14.
n
Insert precision round steel rod or straight drill bit
approximately 3 in. (76.2 mm) long into chuck and
tighten.
n With table raised to working height and locked on
column, place combination square flat on table beside
rod or bit.
n If an adjustment is necessary, loosen the set screw
under bevel lock with a 3 mm hex key, then loosen the
table bevel lock bolt with the hex box wrench (included).
(This adjustment is located under the table).
n Align the table square to the bit by rotating table until the
square and rod or bit are in line.
n Retighten table bevel lock.
n Retighten set screw.
Fig. 13
Fig. 14
LIGHT
BULB
LENS
SCREWS
®
®
COMBINATION
SQUARE
TABLE BEVEL
LOCK BOLT
SET SCREW